HOW TO SETUP EPSON XP-340 PRINTER?

 UNBOXING

Take the printer out of its box and discard the protective tapes and cover materials.

Open the scanner unit and remove the materials like plastic tapes and sheets that were used for protection.

Now, close the scanner unit.

SWITCHING ON

Use the power cord that was provided with the printer to connect the printer to the wall socket.

Press the Power button on the printer's control panel.

On the printer display, use the navigation keys and change the language settings.

INSTALLING INK CARTRIDGE

Raise the scanner unit and check if the holder position is normal.

Take the ink cartridge packet and slowly shake it before using it.

Now, unwrap the cartridge and discard the yellow tape from it.

Ensure you do not touch the contacts that were covered before.

Next, insert the ink cartridges in the respective color slots.

Push the cartridge into the slot and stop when it locks in a position.

Similarly, insert all the ink cartridges into the Epson XP-340 printer.

Close the printer's scanner unit and press the Start button on the control panel.

The ink begins to charge in the printer, so please wait until this process is over.

A message appears on the printer screen when the ink charging is done.

FEEDING PAPER

Fold the feeder guard in the front position.

Extend the paper support and gently press it backward.

Now, move the edge guide to the left end.

Place the paper on the paper support with its printable face on top.

Position the paper such that its edges touch the right side of the feed slot.

Now, adjust the edge guide and paper edges such that the edge guide does not bend the paper.

Again, fold the feeder guard backward.

To modify (or alter) your paper settings, use the control panel.

Next, install the printer software to control the printer operations.